|
Some air pressure systems
contaminate the out coming air with the compressor oil.
Be sure the air you're using is free of oil mist,
because even a minimum oil presence can affect the
adherence of the Multicoating . An alternative is to
use an oil filter.
A wet cloth at hand is a
must, in order to wipe out fast any undesirable splash.
Don't be confident in the underbody conditions you see.
Frequently, old graphite coats and oil residues are not
visible. That's the reason for a careful degreasing
process.
Do not try to mix the
Multicoating with any other liquid or solvent, even
with water.
In case you observe some
dripping it will be due to two causes: Drops of water
remaining from the wash process or a too thick
application (3 millimeters or more). |
If any drop of
Multicoating falls on your clothes, wet it immediately, as
once dry it will be impossible to remove from the fabric.
Avoid applying
Multicoating on the exhaust system. If this happens, the
product is resistant to 185š C, but some plastic odor
would appear temporary.
The product bottles must
be closed and kept in shade. Avoid heating.
If you did some masking
during an application, remove the adhesive tape quickly
when wet, before the film dries.
Thicker application (more
than 2 millimeters) is not advisable, cause they won't
perform better properties.
Small repairs can be
achieved by means of a hand brush, moving it in short
pulse perpendicular to the surface. This will produce a
very similar texture than original. |
