Remove all rust scale, oil and grease from surface to be coated.

Wash the area and use a water-based degreaser, preferably a citrus-based product.

Apply with the RA-88 Total Coat spray gun (or similar), set at 20 – 40 psi.

Do not dilute with water. Dilution will negatively change the chemical properties.

Recommended single coating thickness is 1,0 to 1,5 mm (1/16¨). As a visual guide, an “orange peel” look will be observed in the coating.

Small repairs on gauges or scratches can be achieved by means of a hand brush, moving it in short pulse perpendicular to the surface.

This will produce a very similar texture than original.

If you did some masking during an application, remove the adhesive tape quickly when wet, before the film dries.
1 bottle covers up to 15 square feet.
 

:: back to top

Air drying only: 12 hours at 72 F minimum. Do not apply under 72 F. Do not apply below 40% RH.

Keep away from water direct contact for 8 hours. High air humidity and/or poor ventilation will slow down the drying process. The use of fans will help in reducing drying time.
 

Over spray can be wipe off with a wet rag before product dries. Use water only to clean sprayer, clothes or any oversprays.

In case of spills, rinse with water, or let dry and dispose it as a plastic.

Keep from freezing.          

Some air pressure systems contaminate the out coming air with the compressor oil. Be sure the air you’re using is free of oil mist, or install an oil filter.

Do not try to mix the Sound Control Marine with any other liquid or solvent, even with water.

In case you observe some dripping it will be due to two causes: Drops of water remaining from the wash process or a too thick application (3 millimeters or more).

If any drop of Sound Control Marine falls on your clothes, wet it immediately, as once dry it will be impossible to remove from the fabric.

Avoid applying Sound Control Marine on hot machine parts. If this happens, the product is resistant to 185º C, but some plastic odor would appear temporary.

The product bottles must be closed and kept in shade. Avoid heating.